Packaged refrigeration units

Self-contained monoblock units for wall-mount installation in small cold rooms at positive and negative temperature.


INTARBLOCK series are monoblock refrigeration units for wall-mounting installation in small cold rooms to freeze or store all kind of products.

INTARBLOCK SERIES combines both refrigeration technologies and traditional solutions, featuring a very compact design, a high degree of robustness, low weight and a minimum refrigerant load. The structure and body are built in prelacquered galvanised steel shell and polyester paint.
Every unit has been fully tested in factory to guarantee an optimal and non-stopped performance under the most severe conditions.

  • Series MCV-N / BCV-N: Monoblock units are designed for plug-in mounting, including removable insulation pad, from 0,6 to 3,0 kW for mid-temperature and from 4,8 to 2,4 kW in low-temperature.
  • SeriesMCV-C / BCV-C: Monoblock centrifugal version with condensation unit features a centrifugal fan for a ducted outlet of condenser’s hot air, from 0,8 to 3,0 kW in mid-temperature and from 4,9 to 2,4 kW in low-temperature.
  • Tropicalized design for high ambient temperature up to 45 ºC
  • Thermostatic expansion valve
  • Hot gas defrosting with evaporator temperature control
  • Low refrigerant load, less than 2 kg.

  • 230 V-I-50 Hz or 400 V-III-50 Hz power supply.
  • R-134a / R-449A refrigerant load, below 2.0 kg.
  • Hermetic reciprocating compressor.
  • High and low pressure switches.
  • Thermostatic expansion valve.
  • MCB protection.
  • Hot gas defrost.
  • Stainless steel drain pan.
  • Evaporation of condensed water.
  • Cold room lamp and door micro-switch cable.
  • Door heater cable (only for BCV series).
  • Removable through-wall insulation pad included.
  • Multifunction electronic control.


  • Change to 400 V-III-50 Hz power supply.*
  • Door micro-switch.
  • Non-return damper (centrifugal version).
  • Adaptation of air discharge to circular duct.
  • Evaporator coil epoxy anti-corrosion treatment.
  • Change to R-452A refrigerant for negative temperature.


  • Change to 400 V-III-50 Hz power supply. *
  • Door micro-switch.
  • Condenser coil polyurethane anti-corrosion treatment.
  • Evaporator coil epoxy anti-corrosion treatment.
  • Male and female schuko electrical connector base.
  • Low voltage protection (monophase models).
  • Low voltage protection and phase sequence protection (three-phase models).

You've just added this product to the cart: